| Scan Mode: |
| --source ADF|FB [ADF] |
Selects the scan source (such as a document-feeder). |
| --mode Lineart|Halftone|Gray|Color [Lineart] |
Selects the scan mode (e.g., lineart,monochrome, or
color). |
| --duplex front|back|both [front] |
Select if you want the front or back to be scanned,
or both. |
| --resolution 200|240|300|400|600dpi [400] |
Sets the horizontal resolution of the scanned image. |
| --y-resolution 200|240|300|400|600dpi [400] |
Sets the vertical resolution of the scanned image. |
Geometry: |
| -l 0..308mm (in steps of 0.0211639) [0] |
Top-left x position of scan area. |
| -t 0..438mm (in steps of 0.0211639) [0] |
Top-left y position of scan area. |
| -x 0..308mm (in steps of 0.0211639) [215.893] |
Width of scan-area. |
| -y 0..438mm (in steps of 0.0211639) [296.994] |
Height of scan-area. |
| --pagewidth 0..308mm (in steps of 0.0211639)
[215.879] |
Usually it's ok to just leave it at the maximum value
all the time, but the ADF behavior may change if this
value is modified |
| --pageheight 0..438mm (in steps of 0.0211639)
[296.989] |
Usually it's ok to just leave it at the maximum value
all the time, but the ADF behavior may change if this
value is modified |
Enhancement: |
| --threshold 0..255 (in steps of 4) [128] |
Select minimum-brightness to get a white point |
| --contrast 0..255 (in steps of 1) [0] |
Controls the contrast of the acquired image. |
| --rif[=(yes|no)] [no] |
reverse image format |
| --compression None|JPG_BASE_LINE [None] |
use hardware compression of scanner |
| --dtc_selection Default|Simplified|Dynamic
[Default] |
DTC selection |
| --gamma Default|Normal|Soft|Sharp [Sharp] |
specifies the gamma pattern number for the line art
or the halftone |
| --emphasis None|Low|Medium|High|Smooth
[None] |
image emphasis |
| --paper_size A3|A4|A5|Double|Letter|B4|B5|Legal|Custom|Autodetect
[Custom] |
Physical size of the paper in the ADF |
| --orientation Portrait|Landscape [Portrait] |
Orientation of the paper in the ADF |
Fine tuning and debugging: |
| --buttons off|on [off] |
Activate the buttons and functionkeys.
Resolution and other options may be overwritten by the
button config-file. |
Type ``ScanDoX V0.9Beta --help -d DEVICE'' to get list
of all options for DEVICE. |
List of available devices:fujitsucert:/dev/sg2 |
